LEMKEN Saphir 8 AutoLoad Operating Instructions Manual page 13

Safety Instructions
Maintenance
 Repair-, maintenance- and cleaning operations as well as adjustments and
remedy of function faults should principally be conducted with engine stopped
and brakes applied. Remove ignition key!
 Check and tighten nuts and bolts regularly!
 When conducting maintenance work on a lifted implement always place suit-
able supports underneath!
 For replacing any tools with cutting edges always use suitable tools and gloves!
 Dispose of old oils, grease and filters as prescribed by law.
 Before working on the electric gear disconnect battery cables!
 When conducting electrical welding operations on the tractor or on the mounted
implement remove cable from the generator and the battery!
 Any spare parts fitted must meet with the implement manufacturer's fixed tech-
nical standards! This is for example ensured by using genuine spare parts!
 To avoid danger of explosion only use nitrogen for filling up gas tanks!
Seed Drills
 During the calibration test watch out for rotating or oscillating parts of the im-
plement!
 Use only steps for filling. It is not allowed to travel on the steps during operation!
 When filling the hopper adhere to the instructions of the manufacturer!
 Lock track markers in transport position!
 Never place any parts inside the hopper as the agitator shaft rotates, even dur-
ing preparation work e.g. calibration!
Never exceed the maximum allowed filling quantity!

11