2 GETTING STARTED
2.1 Connecting the Repeater to a PC
2.1
Connecting the Repeater to a PC
To write the configuration data to or read the configuration data from the repeater, the repeater and a PC with KPG-
174D installed need to be connected by using the KPG-46A/ KPG-46U/ KPG-46X programming cable.
Using KPG-46A:
Note
If no RS-232C communication port is available on a PC, convert the USB port on the PC to DB 9-pin, and then connect the
KPG-46A.
Using KPG-46U/ KPG-46X:
FUNC (E)/Ver 2.50
To the Microphone Connector
KPG-46A
Figure 2-2 KPG-46A
To the Microphone Connector
KPG-46U/ KPG-46X
Figure 2-3 KPG-46U/ KPG-46X
To RS-232C Port
(D-sub 9-pin male)
To a USB Port
CONTENTS
INDEX
7