Repeater Operation; Selecting The Offset Direction; Automatic Offset Selection - Kenwood TH-28A Instruction Manual

REPEATER OPERATION
1 Transmitter Offsets 3 Automatic Offset Selection
All amateur radio repeaters use a separate receive m U.S.A. and CANADA versions
and transmit frequency. The receive frequency may
be above or below the transmit frequency. Most
repeater configurations fall into one of the following
The TH-28A is programmed according to the
standard ARRL(Amateur Radio Relay League) Band
Plan for repeater offset direction. You can override
Gated Ones: this programming by using the SHIFT key as
described in the preceding paragraph.
Offset mw European version
Direction TH-28A/E TH-48A TH-48E
The TH-28E automatic offset is programmed as
+ +600 kHz| +5 MHz | + 1.6 MHz follows.
— | 600 kHz) —5 MHz | —1.6 MHz
=
| = 7.6 MHz
144.00
145.600 145.800
SIMPLEX ; —600 kHz | SIMPLEX
2 Selecting the Offset Direction
Press the SHIFT key. The transceiver will shift from m@ To cancel automatic offset
one offset direction to the other, such as from + to
; SD Press and hold the CALL key and switch the power
—, or from — to simplex where no indicator shows.
on.
In the European version (UHF band ), —change
to—--—.
This operation switches automatic offset mode on or
off.
27