Kenwood TKR-D710 Function Reference page 84

8 CW ID
8.8 CW ID Override
8.8 CW ID Override
CW ID Override is the function to send a CW ID along with an audio signal even if the repeater is still transmitting
when the amount of time configured in Transmit Interval Time elapses.
If this function is enabled, the repeater sends the CW ID along with the audio signal even if the repeater is still
transmitting when the amount of time configured in Transmit Interval Time elapses.
If this function is disabled, the repeater sends the CW ID after ending the transmission if the repeater is still
transmitting when the amount of time configured in Transmit Interval Time elapses.
Note
• This function cannot be used on a DMR digital channel.
• If the repeater sends a CW ID for which CW ID Override is enabled during transmission, the currently used QT tone or DQT
code is sent regardless of the configuration in Encode with QT/DQT.
• If this function is disabled, the repeater does not send a CW ID even if the CW ID On function becomes active while the
repeater is transmitting.
Configuration using KPG-174D
Configuring CW ID Override to be enabled or disabled (
ID)
FUNC (E)/Ver 2.50
Voice Call
Transmit Interval Time Start Interval
CW ID
Transmit
Figure 8-5 CW ID Override
Active Inactive
Interval Interval
Transmit
Edit > Channel Information > Channel Edit > CW
See
CONTENTS INDEX 66