Tot Reset Time - Kenwood TKR-D710 Function Reference

4 TRANSMISSION/ RECEPTION/ REPEAT
4.7 Restricting the Continuous Transmission Time (Time-out Timer (TOT))

TOT Reset Time

TOT Reset Time is the length of time until the elapsed time for Time-out Timer is initialized and reset to zero.
Example 1: Time-out Timer: 30 sec, TOT Reset Time: 10 sec
Also, retransmission within the configured time of TOT Reset Time 1 is treated as continuous transmission by the
repeater. In the following example, the countdown for Time-out Timer continues because transmission is started by
using the PTT (microphone) switch or the Console PTT control while the TOT Reset Time is counting down.
Example 2: Time-out Timer: 30 sec, TOT Reset Time: 10 sec
Note
• If "Off" is configured in TOT Reset Time, Time-out Timer is immediately reset after the repeater ends transmission.
• If transmission is started by using the Repeat PTT control or the Network PTT control while the TOT Reset Time is counting
down after transmission by using the Console PTT control ends, Time-out Timer for the Console PTT control is reset.
Configuration using KPG-174D
• Configuring TOT Reset Time for transmission using the PTT (microphone) switch (
Features > Common Page 2 > Local Mic PTT)
• Configuring TOT Reset Time for transmission using the Console PTT control (
Common Page 2 > Console PTT)
FUNC (E)/Ver 2.50
PTT
On Off
Transceiver
Transmit Receive
TOT Count Start
TOT Reset Time
TOT Reset Time
Count Start
Time 0 sec 10 sec
Figure 4-3 TOT Reset Time 1
PTT
On
Transceiver
Transmit
TOT Count Start
TOT Reset Time
Count Start
Time 0 sec 10 sec
Figure 4-4 TOT Reset Time 2
On
Transmit
TOT Reset
Count Start
Expire
20 sec 25 sec 30 sec 55 sec
Off On
Receive Transmit
Expire TOT
TOT Reset Time
Reset
20 sec 30 sec
Expire TOT
Edit > Optional
See
Edit > Optional Features >
See
CONTENTS INDEX 21