Starting; Starting The Engine - Fayat Group DYNAPAC CC224C Instruction Manual

2
Fig. Control panel
1. F/R lever
2. Rpm switch
3. Ignition key
Figure. Display - Status image
2021-03-16

Starting

Starting the engine

Make sure that the emergency stop is OFF and the
parking brake ON.
1
Set the forward/reverse lever (1) in neutral position,
and set the speed selector (2) in the idling position
(LO) or (ECO) if that option is installed on the machine.
The diesel engine cannot be started in any other
position of the controls.
3
Turn the ignition key (3) right to position I and wait for
the grid heater symbol to disappear from the display.
Then engage the starter by turning it full right. Release
back to I as soon as the engine starts.
At the start of the diesel engine when the ambient
temperature is below +10 ° C (50 ° F), it must be
warmed up at idle (low speed) until the hydraulic oil
temperature exceeds +10 ° C (50 ° F).
Check during warming up of the engine that fuel and
water levels are shown correctly and that the voltage
is at least 24V.
4812159701_D.pdf
While preheating of diesel engine is running the While preheating of diesel engine is running the
symbol grid heater is shown in the center of the symbol grid heater is shown in the center of the
display. display.
Do not run the starter motor for too long (max. 30 Do not run the starter motor for too long (max. 30
seconds). If the engine will not start, wait a seconds). If the engine will not start, wait a
minute before trying again. minute before trying again.
Ensue that there is good ventilation (air extraction) Ensue that there is good ventilation (air extraction)
if the engine is run indoors. Risk of carbon if the engine is run indoors. Risk of carbon
monoxide poisoning. monoxide poisoning.
Operation
65