Table of Contents
Advertisement
1
Figure. Front drum
1. Nozzle
6
4
5
Figure. Pump system, front frame
right side
1. Coarse filter
2. Stop cock
3. Drain cock kran, filter
4. Water pump
5. Drain cock
6. Extra pump (optional)
104
Sprinkler system/Drum
Check
Start the sprinkler system and make sure that none of
the nozzles (1) are clogged. If necessary, clean
blocked nozzles and the coarse filter placed by the
water pump (2). See next section.
Newer machines can have sprinkler systems with dual
sprinkler pipes and sprinkler pumps as standard.
Cleaning the coarse filter
To clean the coarse filter (1) open the drain cock (3)
1
on the filter and allow any dirt to run out.
If necessary close the cock (2) and clean the filter and
filter housing. Check that the rubber gasket in the filter
housing is intact.
2
After inspecting and cleaning, reset and start the
system to check that it works.
There is a drain cock (5) in the space for the pump
3
system. This can be used to drain the tank and the
pump system.
An extra pump (6) can be installed in case the
standard water pump stops working. See section for
emergency watering.
To drain the complete sprinkler system, see section for
Watering system - Draining, 2,000 h.
4812159701_D.pdf
Maintenance, 10h
2021-03-16
Advertisement
Table of Contents
