Table of Contents
Advertisement
Fig. Brake disengagement valve
1. Valve
2. Pump arm
3. Knob
Fig. Towing
2021-03-16
Short distance towing when the engine is
inoperative.
2
3
Open both towing valves as described earlier.
The brake disengagement pump is located behind the
1
left door of the engine compartment.
Make sure that the valve (1) is closed, this is done by
tightening clockwise with the knob (3). Pump with the
pump arm (2) until the brakes are disengaged.
Ensure that the valve is reset into open position after
finished towing. This is done by turning the knob
counter clockwise to full extracted position.
Towing the roller
When towing/retrieving a machine, the towing device
must be connected to both lifting holes in the diagram.
The load is uniformly divided between the two lugs.
The pulling forces should act parallel to the machine's
longitudinal axis, as shown in the figure. See table
below for maximum permitted pulling force.
4812159701_D.pdf
Chock the drums to prevent the roller from moving
Chock the drums to prevent the roller from moving
when the brakes are hydraulically disengaged.
when the brakes are hydraulically disengaged.
When towing/recovering, the roller must be braked
When towing/recovering, the roller must be braked
by the towing vehicle. A towing bar must be used
by the towing vehicle. A towing bar must be used
as the roller has no brakes.
as the roller has no brakes.
The roller must be towed slowly, max. 3 km/h (2
The roller must be towed slowly, max. 3 km/h (2
mph) and only towed short distances, max. 300 m
mph) and only towed short distances, max. 300 m
(330 yards).
(330 yards).
Model
Model
CC224-384, CC2200-3800
CC224-384, CC2200-3800
CC424-624, CC4200-6200
CC424-624, CC4200-6200
Reverse the towing preparations made to the
Reverse the towing preparations made to the
hydraulic pump and/or the motor.
hydraulic pump and/or the motor.
Miscellaneous
kN
kN
lbf
lbf
140
140
31 500
31 500
190
190
42 750
42 750
85
Advertisement
Table of Contents
