Emergency Braking; Switching Off - Fayat Group DYNAPAC CC224C Instruction Manual

2
Fig. Control panel
1. Emergency stop
2. Parking brake
3
Fig. Control panel
1. Display
2. Ignition lock
3. Parking brake
76

Emergency braking

Braking is normally activated using the
forward/reverse lever. The hydrostatic transmission
1
retards and slows the roller when the lever is moved
towards the neutral position.
A disc brake in each drum motor/drum gear and the
rear axle also acts a secondary brake when in motion,
and as a parking brake when stationary. Activated with
the parking brake (2).
The Diesel engine will stop and must be restarted.
After emergency braking, return the forward/reverse
lever to neutral and deactivate the emergency stop.

Switching off

Set the speed control in idling position and allow the
1
engine to idle for a few minutes to cool down.
Check the display to see if any faults are indicated.
Switch off all lights and other electrical functions.
Activate the parking brake (3) and then turn the
ignition lock (2) to the left to the off position.
2
Fit the instrument cover on the display and top of the
control box (on rollers without cab), and lock it.
4812159701_D.pdf
For emergency braking, press the emergency stop For emergency braking, press the emergency stop
(1), hold the steering wheel firmly and be prepared (1), hold the steering wheel firmly and be prepared
for a sudden stop. The engine stops. for a sudden stop. The engine stops.
Operation
2021-03-16