Table of Contents
Advertisement
3
2
Figure. Engine compartment under
hydraulic tank (via left side)
1. Oil drain
2. Hydraulic tank
3. Valve
Fig. Fuel tank
1. Oil drain pump
2021-03-16
Hydraulic reservoir
Fluid change
1
Open left engine compartment. The drain plug/valve is
in the area under the hydraulic tank.
Place a receptacle that holds at least 50 liters (13.2
gal) under the engine compartment.
Make sure that the valve (3) is closed.
Unscrew the oil drain plug (1), and connect a drain
hose out from the engine compartment.
Open the valve (3) and allow all the oil to run out.
Reset by closing the valve and refitting the plug (1).
Fill with fresh hydraulic fluid. Refer to the lubricants
specification for grade information.
Replace the hydraulic filter. See section "Maintenance
- 1000 hours".
Start the engine and operate the hydraulic functions.
Check the level in the reservoir and top off as required.
Fuel tank
- Cleaning
It is easiest to clean the tank when it is almost empty.
1
A drain plug is placed under the left side of the front
frame.
Alternatively drain the tank with a suitable pump, e.g.
an oil drain pump, to bring up any bottom sediment.
4812159701_D.pdf
Maintenance - 2000h
Take care when draining the hydraulic fluid. Wear
Take care when draining the hydraulic fluid. Wear
protective gloves and goggles.
protective gloves and goggles.
Deliver the drained fluid to environmentally
Deliver the drained fluid to environmentally
correct handling.
correct handling.
Collect the fuel and sediment in a container and
Collect the fuel and sediment in a container and
deliver to environmentally correct handling.
deliver to environmentally correct handling.
Keep in mind fire risk when handling fuel.
Keep in mind fire risk when handling fuel.
151
Advertisement
Table of Contents
