Table of Contents
Advertisement
Figure. Switch
1. Edge cutter/compactor Up/Down
2. Sprinkler, edge cutter/compactor
4
1
3
Fig. Changing the tool
1. Edge compactor
2. Edge cutter
3. Bolted joint
4. Holder for cutter/compactor wheel
2021-03-16
Edge cutting (Optional)
The machine must be running to activate the edge
cutter/compactor.
When the machine is in the operating position and the
1
switch (1) is pressed at the bottom, the edge
2
cutter/compactor is lowered to the asphalt surface by
means of a hydraulic cylinder. To reset the edge
cutter/compactor in its original position, press the top
of the switch to lift the edge cutter/compactor.
The edge cutter/compactor can also be lifted if the
machine is in transport position.
A bypass valve prevents the hydraulic system being
overloaded.
There is a separate sprinkler system which the
operator should use to avoid asphalt sticking to the
edge cutter/compactor. The system is operated with a
switch (2). The water is drawn from the main water
tank, which is also used for the normal sprinkler
system.
The operator can choose between two tools, the edge
cutter or edge compactor. The edge cutter (1) in the
figure is shown in the operating position. The edge
compactor (1) can easily be replaced with the edge
cutter by releasing the bolted joint (3).
3
2
4812159701_D.pdf
Operation
73
Advertisement
Table of Contents
