Fuji Xerox DocuCentre SC2020 Service Manual page 93

050-101 IOT Remain Zone LH-1 JAM
BSD-ON:-
Detected leftover paper near LH-1.
Cause/Action
1. Open Cover [A] by raising the release lever.
2. Remove the paper which was the cause.
3. Press the center of Cover[A] and close it tightly.
4. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-102 IOT Remain Zone LH-1 + DUP-1 JAM
BSD-ON:-
Detected leftover paper near LH-1 + DUP-1.
Cause/Action
1. Open Cover [A] by raising the release lever.
2. Remove the paper which was the cause.
3. If there is paper insider Cover [A], remove that paper as well.
4. Press the center of Cover[A] and close it tightly.
5. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-103 IOT Remain Zone LH-1 + DUP-2 JAM
BSD-ON:-
Detected leftover paper near LH-1 + DUP-2.
Cause/Action
1. Open Cover [A] by raising the release lever.
2. Remove the paper which was the cause.
3. If there is paper insider Cover [A], remove that paper as well.
4. Press the center of Cover[A] and close it tightly.
5. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-104 IOT Remain Zone LH-2 JAM
BSD-ON:-
Detected leftover paper near LH-2.
Version 1.1
DC SC2020
Cause/Action
1. Open Cover [A] by raising the release lever.
2. Pull LeverA1 and open the Chute.
3. Remove the paper which was the cause.
4. Return LeverA1 to the original position.
5. Press the center of Cover[A] and close it tightly.
6. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-106 IOT Remain Zone LH-2 + DUP-2 JAM
BSD-ON:-
Detected leftover paper near LH-2 + DUP-2.
Cause/Action
1. Open Cover [A] by raising the release lever.
2. Pull LeverA1 and open the Chute.
3. Remove the paper which was the cause.
4. Return LeverA1 to the original position.
5. If there is paper insider Cover [A], remove that paper as well.
6. Press the center of Cover[A] and close it tightly.
7. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-109 IOT Remain Zone LHL JAM
BSD-ON:-
Detected leftover paper near LHL.
Cause/Action
1. Open Cover [B] by raising the release lever.
2. Remove the paper which was the cause.
3. Press the center of Cover[B] and close it tightly.
4. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-112 IOT Remain Zone MSI JAM
BSD-ON:-
Detected leftover paper near MSI.
Cause/Action
1. Check the inside of the manual bypass tray (around insertion port of the paper) and remove any
jammed paper.
05/2014
2-71
CHAIN 50
Troubleshooting