Fuji Xerox DocuCentre SC2020 Service Manual page 594

DC SC2020
Version 1.1
6.4.3 Overview of the CE Mode Operation
After the CE mode is started, you can use the buttons displayed in the touch panel to operate the CE
mode.
There are two types of the diagnostic procedure: Printer Diag and Fax/Scanner Diag.
1. Selecting the item to execute the diagnosis
Use the [Up arrow] and [Down arrow] buttons to select the item to execute diagnosis.
2. Confirming the item to execute the diagnosis
Press the [OK] button to confirm the item selected.
3. Executing the diagnosis for the item selected
Follow the message and keep holding down the [OK] button until the diagnosis is started.
If the diagnosis requires changing the parameter value, use the [Up arrow] and [Down arrow] but-
tons and then press the [OK] button.
To execute the diagnosis for other items, press the [<--] (Back) button until the screen returns to the item
to evaluate.
If any error occurs while in the diagnosis or in the middle of selecting parameter values, an error mes-
sage will appear and the processing will stop.
To cancel the error message and return to the menu screen, press the [<--] (Back) button or the [OK] but-
ton.
05/2014
6-196
6.4.4 How to Exit the CE Mode
You can exit the CE mode both from Printer Diag and Fax/Scanner Diag.
1. Return to the top level of Printer Diag or Fax/Scanner Diag, and use the [Up arrow] or [Down arrow]
button until the [Complete] appears, and then press the [OK] button.
(e.g.: To exit the CE mode from Printer Diag, display the message below.)
2. Press the [OK] button.
3. Press the [OK] button again, and the MPF will exit the CE mode and re-start (same as the power
on).
6.4.3 Overview of the CE Mode Operation
Figure 1 j0bs64004
Figure 2 j0bs64005
General