Rep 56.2.5 (Scc) Dadf Feeder Assembly - Fuji Xerox DocuCentre SC2020 Service Manual

REP 56.2.5 (SCC) DADF Feeder Assembly

Parts List on PL 56.2
Removal
WARNING
When turning OFF the power switch, check that the 'Data' lamp
is OFF and that there is no Job in progress.
Turn OFF the power switch and make sure that the screen dis-
play or the Power Saver LED turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the DADF Front Cover. (REP
2. Remove the DADF Rear Cover. (REP
3. Remove the Document Tray. (REP 56.9.1)
4. Remove the Harness Guide and the wire harness.
56.6.1)
5. Remove the Upper Feeder. (REP 56.2.4)
6. Disconnect the connector of the Exit Nip Release Solenoid.
(Figure 1)
(1) Disconnect the connector.
Figure 1 j0lj45643
7. Remove the screws that secure the DADF Feeder Assembly at
the rear. (Figure 2)
(1) Remove the Tapping Screw (x3).
Version 1.1
DC SC2020
56.2.1)
56.2.2)
(REP
8. Remove the DADF Feeder Assembly. (Figure 3)
(1) Remove the Tapping Screw (x3).
(2) Remove the DADF Feeder Assembly.
Reference: This shows the removed DADF Feeder Assembly.
(Figure 4)
Figure 2 j0lj45644
Figure 3 j0lj45645
05/2014
4-79
Figure 4 j0lj45646
Replacement
1. To install, carry out the removal steps in reverse order.
Disassembly/Assembly and Adjustment
56. DADF