Right Click On Enet [Link 100] In The Routing Table - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

10-6 Initiate ControlNet to DH+ Communication With an Ethernet Backbone
You select this to include the
1756-ENET module in the right
chassis in the routing table.
In the next section we describe how to
configure the 1756-ENET module in
the right chassis.
This is the backplane of the right
chassis. Look for this just below the
new 1756-ENET entry (address
130.130.130.2).
Publication 1756-6.5.13 - September 1999
j. Right click on ENET [Link 100] in the routing table.
k. Select Add Module.
l. Select 1756-ENET and click on OK.
m. Enter the following configuration and click on OK:
IP Address 130.130.130.2
Link ID 0
n. Right click on the new Backplane [Link Undefined].
o. Select Add Module.
p. Select 1756-CNB and click on OK.
q. Enter the following configuration and click on OK:
Slot Number
Link ID of ControlNet
1
101