Install The Ethernet Communication Modules - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

2-10 Set Up the Hardware
To complete the example applications
EXAMPLE
as described in the following chapters,
modify your system as shown in the
system diagram on the first page of
each example chapter (chapters 5
through 10). To complete the first
example, install the 1756-ENET
module in slot 2.
b
Slide the module into the chassis.
Make sure the module properly
connects to the chassis backplane.
Publication 1756-6.5.13 - September 1999

Install the Ethernet Communication Modules

Install the modules.
Install the module in any slot.
a
Align the circuit board with top and
bottom guides in the chassis.
c
The module is fully installed when it is
flush with the power supply or other
installed modules.