Configure The Plc-5 Processors - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

Configure the PLC-5 Processors

Card Guides
Set the controlNet network addresses using the two
10-digit rotary switches on top of the module.
EXAMPLE To complete the example applications in chapters 8
and 10, set the ControlNet address of one processor
to node 1 and the other processor to node 2.
Set the backplane switches on the I/O chassis for the
PLC-5/40c processors.
EXAMPLE
Put switches 5 and 6 in the "on" position, then put all
of the others in the "off" position. You need to set these
switches so that you can download the ladder logic
program in the example applications.
Install the processor module.
Install the PLC-5 processor in an appropriate I/O chassis.
If you need help, see the ControlNet 1.5 PLC-5
Programmable Controller User Manual, publication
1785-6.5.22.
Locking Bar
Lift Ejector Tab
PLC-5/40C Processor
Battery
Connector
Battery
Cover
Battery
Define the DH+ station address of channel 1A by
setting switch assembly SW-1 on the back of the
processor. (See the side of the processor if you want
to use another address.)
side view of processor
side view
down
230 Kbaud
up
The 1756-DHRIO module's DH+ ports
57.6 Kbaud
currently support 57.6 Kbaud only, so
set switch 7 in the "up" position.
EXAMPLE
To complete the example applications set the
DH+ node address of one processor to node 10
and the other processor to node 1.
ControlNet PLC-5 processor's NET address = 1
20 30
10
40
00
50
90 60
80 70
Publication 1756-6.5.13 - September 1999
Set Up the Hardware 2-3
2 3
1
4
0
5
9 6
8
7