Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual page 39

f. If no program is loaded in the PLC-5/40C processor, a pop-up window
will appear with the message "You cannot go Online to DEFAULT
program." Enter a new processor name of your choice (e.g., "Receiver")
and click on OK.
• It is not necessary to save the program.
• Disregard any warnings about Control Net devices.
g. Double-click on N7 in the data file list.
You should see the following screen:
Verify that this value is being updated.
When you see N7:0 being updated at one second intervals the message is
being sent successfully from the PLC-5/40C processor at node 10 to the
PLC-5/40C processor at node 1.
Initiate DH+ to DH+ Communication Via a Single Gateway Module
Publication 1756-6.5.13 - September 1999
5-9