Test The Ktx Driver And System Hardware Setup - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

6-2 Initiate DH+ to DH+ Communication Via Two Gateway Modules
Publication 1756-6.5.13 - September 1999

Test the KTX Driver and System Hardware Setup

Start the RSLinx software.
From the Communications menu in RSLinx, select RSWho.
a. Select the AB_KT-1 driver. Drill down until you see the 1756-DHIO
modules in slots 1 and 3 displayed. Expand the view to verify the
channel A and channel B configurations for both modules. You should
see a display similar to that below:
b. If you do not see the correct display, check the faceplate indicators to
ensure the DHRIO modules are functioning properly. Verify that the
modules and cables are properly connected and the switch settings on the
modules are correct. See page 2-7.
If you are still experiencing difficulty verify that the 1784-KTX
driver is configured properly. Make sure there is no conflict with
other hardware in your PC workstation.
Minimize RSLinx.