Install The Software - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

Install the software (page 3-1).
Configure the communication
cards (page 3-2).
Start the configuration software
(page 3-2).

Install the Software

To use these software packages, you need:
-computer with a Pentium 166 MHz or greater processor
-at least 32MBytes of RAM
-hard drive with adequate free space
(25 MBytes or greater)
- 3.5 inch, 1.44 MByte disk drive
-VGA or higher-resolution adapter/monitor
(640x480, 800X600, 1024x786 modes supported)
-Windows-supported pointing device
-Microsoft Windows NT version 4.0 or later
-RSLinx version 2.10 or later
(included with catalog number 1756-GTWY)
-an Ethernet card
Set Up the Software
Install RSLogix5, RSLinx, and ControlLogix Gateway Configuration
software as follows:
Install the software:
For each of the three software packages:
a. From the Start menu, select Run.
b. Enter a:\setup.
Publication 1756-6.5.13 - September 1999
3
Chapter