Install The Controlnet Communication Modules - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

2-12 Set Up the Hardware
Set the node address switches on the 1756-CNBR or -CNB module.
side of module
Install the module.
a
EXAMPLE
To complete the example applications as described in the following chapters, modify your system as shown in the
system diagram on the first page of each example chapter (chapters 5 through 10). To complete the first example,
install the 1756-ENET module in slot 2.
Publication 1756-6.5.13 - September 1999

Install the ControlNet Communication Modules

This modules's network
address is 23.
Valid addresses are 01 to 99.
b
!
top of module
ATTENTION: Do not force the module into the
backplane connector. If you cannot seat the module
with firm pressure, check the alignment. Forcing the
module into the backplane can damage the backplane
connector or the module.