Test The Ktx Driver And System Hardware Setup - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

5-2 Initiate DH+ to DH+ Communication Via a Single Gateway Module
Publication 1756-6.5.13 - September 1999

Test the KTX Driver and System Hardware Setup

Start the RSLinx software.
From the Communications menu in RSLinx, select RSWho:
a. Select the 1756-DHRIO module from the AB_KT-1 driver. Drill down
the backplane until you see the channel A and channel B configurations
displayed. Expand the tree under the driver. You should see a display
similar to that below (channel A configured as node 3, channel B
configured as node 4, etc.):
b. If you do not see the correct display, check the faceplate indicators to
ensure the DHRIO module is functioning properly. Verify that all
modules and cables are properly connected and that switch settings are
correct. See page 2-7.
If you are still experiencing difficulty verify that the 1784-KTX
driver is configured properly. Make sure there is no conflict with
other hardware in your PC workstation.
Minimize RSLinx.