Test The Ktx Driver And System Hardware - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

7-2 Initiate Ethernet to DH+ Communication
Publication 1756-6.5.13 - September 1999

Test the KTX Driver and System Hardware

Start the RSLinx software.
From the Communications menu in RSLinx, select RSWho:
a. Select the AB_KT-1 driver. Drill down until you see the 1756-DHIO
module in slot 1 and the 1756-ENET module in slot 2. Expand the view
to verify the channel A and channel B configurations. You should see a
display similar to that below:
b. If you do not see the correct display, check the faceplate indicators to
ensure the DHRIO and ENET modules are functioning properly. Verify
that modules and cables are properly connected and that switch settings
on the 1756-DHRIO module are correct. See page 2-7.
If you are still experiencing difficulty, verify that the 1784-KTX
driver is configured properly. Make sure there is no conflict with
other hardware in your PC workstation.
Minimize RSLinx.