Test The Application - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

6-6 Initiate DH+ to DH+ Communication Via Two Gateway Modules
This message writes the value of the
seconds clock (S:23) in the PLC-5/40C at
node 10 into data file N7:0 of the PLC-5/40C
processor at node 1.
Publication 1756-6.5.13 - September 1999
If the PLC-5/40C processors do not appear, then verify the switch settings
in the 1756 DHRIO modules and PLC-5/40C processors and check that the
cables are properly connected.
If you are still experiencing difficulty, reconfigure the routing table as
described previously.

Test the Application

Restore or start the RSLogix5 software:
a. From the Windows NT Start menu, select Programs.
b. Select Rockwell Software > RSLogix5 English
OR
Double-click on:
Load the example program for the PLC-5/40C processor at DH+
node 10:
a. From the File menu, open the program "example." See page 4-2.
b. In the MSG instruction, double-click on Setup Screen.