Connect Power - Allen-Bradley AB QUALITY ControlLogix 1756 Series User Manual

2-6 Set Up the Hardware
ATTENTION: Make sure the
chassis is mounted and all panel
!
fabrication is complete before you
remove the protective label. This
label protects the power supply
from metal shavings falling inside
and damaging it during operation.
After you connect power,
remove the protective label.
Publication 1756-6.5.13 - September 1999

Connect Power

1756-PA72
AC Input Power Supply
1756-PB72
DC Input Power Supply
L1 - high side of line power
L2/N - low side of line power
Use #14 AWG 75C copper wire.
Tighten the terminals to a torque of
7 inch-pounds.
+ high side of line power
– low side of line power