Left Menu - Deif SGC 420 Mk II User Manual

4.3.2 Left menu

Select Module and Tools
Settings
User manual 4189341360A EN
1. Module
• Configure the settings for the module, for example,
the display parameters, sleep mode, and
communication.
2. Digital inputs
• Configure the digital inputs.
3. Digital outputs
• Configure the digital outputs.
4. Analogue inputs
• Configure the analogue inputs. You can also add
custom sensor curves to the calibration tables.
5. Engine
• Configure the engine parameters, for example, lube
oil pressure, fuel level monitoring, and speed
monitoring. See the Parameters list for more
information about the different parameters.
6. Timers
• Configure the cranking timers, start/stop timers, and
general timers.
7. Generator
• Configure the generator parameters, for example,
voltage, frequency, current, and load monitoring.
8. Mains
• Configure the mains parameters, for example, voltage
and frequency monitoring.
9. ECU Configuration
• Configure the ECU parameters.
10. Maintenance
• Configure the maintenance alarm, action, ash load,
and due date.
11. Live Data
• Select the data you want to view live. It is also
possible to log and save the data.
12. M-Logic
• Configure M-Logic. The analogue comparator tool is
also available from the M-Logic tab.
13. Language Pack
• Configure the language for the controller display.
14. Smart flash
• Update the controller firmware with smart flash.
1. Smart Connect Language
• Configure the language for the smart connect
software.
Page 27 of 99