Table of Contents
Advertisement
5.4.1
Load histogram
The load histogram shows the engine running hours. The running hours are put into load groups. Use the histogram to
monitor how long the genset operates at a specific load percentage.
The load percentage is calculated using these parameters:
• Generator rating
• CT ratio
5.5
Configuration menu
Configure the parameter settings on the display
1. Push and hold the Stop/Config
2. Push the Start
button to continue to the configuration menu.
3. Enter the password. The default password is 0123.
• Use the Up
and Down
• Select a number with the Start
PASSWORD
4. You can now configure the parameters.
5. To leave the configuration menu, push and hold the Stop/Config
6. The controller exits the menu once your settings have been saved.
User manual 4189341360A EN
button for a minimum of three seconds.
buttons to change the number.
button.
button.
Page 31 of 99
Advertisement
Table of Contents
