Table of Contents
Advertisement
Parameter
SGC Source Address
ECU Source Address
ECU Diagnostic Lamps
Parameter
Amber, Red, Malfunction, Protect
Action
Activation
Activation Delay
5.6.10 Maintenance
Maintenance
Parameter
Alarm Action
Due At Engine Hours
Ash Load Enable
Alarm Due Date
5.6.11 Reset counters
Counters for various values are included for genset and mains. These values can be adjusted, for instance if the controller is
installed on an existing genset or a new circuit breaker has been installed. You can only configure the reset counters from
the display.
Genset
Parameter
Run time
No. of starts
No. of trips
Engine kWh
User manual 4189341360A EN
Range
0 to 253
0 to 253
Range
None
Notification
Warning
Electrical Trip
Shutdown
Never
From Engine Start
From Monitoring On
Always
0 to 60 s
Range
Notification
Warning
10 to 65000 hours
Enable
Disable
dd/mm/yyyy
Range
0 to 60000
0 to 60000
0 to 60000
0 to 60000 kWh
Default
3
0
Default
None
Never
0 s
Default
Notification
250 hours
Not enabled
-
Default
0
0
0
0 kWh
Description
Source address for the SGC.
Source address for the ECU.
Description
Configure the action for the ECU diagnostics
lamps.
Configure when the controller monitors the
diagnostics lamps.
If there is a failure when the delay timer expires,
the action for the ECU diagnostics lamps is
activated.
Description
Configure the alarm action for maintenance.
The maintenance timer is based on running
hours.
Enable this paramter to monitor the ash load.
An alarm occurs when it is the due date.
Description
Offset adjustment of the total running hours
counter.
Offset adjustment of the number of starts.
Offset adjustment of the number of trips.
Offset adjustment of the number of engine
kWh.
Page 51 of 99
Advertisement
Table of Contents
