Table of Contents
Advertisement
2.
INSTALLATION
The 7714HDC comes with a companion rear plate that occupies one slot in the frame. For information on
mounting the rear plate and inserting the module into the frame see section 3 of the 7700FR chapter.
2.1.
VIDEO CONNECTIONS
PGM IN:
Input BNC connector for 10-bit serial digital video signals compatible with the SMPTE 292M
standard. The module needs to be set to a specific video input standard using the on
screen menu at this current time.
PGM OUT:
These two BNC connectors are used to output the converted input video as serial
component video, compatible with the SMPTE 259M standard.
OSD:
This BNC connector is used to output the downconverted input video with on screen display
menus (OSD) superimposed over the video as serial component video. The output can be
selected as with serial digital video compatible with the SMPTE 259M standard or as
analog composite video depending on the setting of jumper J25.
Figure 2-1: Rear Panel
Revision 1.1
7700 MultiFrame Manual
7714HDC High Quality Down Converter
7714HDC - 3
Advertisement
Table of Contents
