evertz 5010 SIE Instruction Manual page 10

The following document describes the changes to the manual relating to the special 5010-SIE-NBC
version. The section numbers of the 5010-SIE manual (version 1.1 printed March 1997) are shown in
bold.
1. Introduction
The following additional features are added to those described in section 1
•
RS-422 serial interface listens to communications between VTR and edit controller and reads time
code and VTR status.
•
Parallel remote control input to encode a GPI status bit into the Source ID VITC.
•
Parallel port outputs added to follow GPI and VCG Keyer On/Off inputs. Parallel port pinout has
changed.
2. Installation
The following sections have been changed to read as follows:
2.1.4 Remote Control Connections
PARALLEL: A 9 pin female 'D' connector used for parallel remote control inputs. Loop through
outputs have been provided on two of the inputs for ease of wiring multiple units in parallel.
These loop through outputs are driven in the software so that they follow the sense of the
respective inputs.
complete description of the parallel remote control input operation).
Pin
1
6
2
7
3
8
4
9
5
SERIAL: A 9 pin female 'D' connector for connection to the RS-232/RS-422 serial
communications. This port is normally uses to sense status information from the VTR supplying
video to the 5010-SIE-NBC
Pin
1
6
2
7
3
8
4
9
5
Date of Issue: September 26, 2001
Each input has an internal pull-up to +5 volts. (See section 3.9 for a
Description
Ground
not used
VCG Keyer On/Off Input
not used
ON AIR VCG Disable Input
not used
GPI Input
VCG Keyer On/Off Output
GPI Output
Description
Ground
no connection
RS-422 Transmit A(-)
RS-422 Transmit B(+)
RS-422 Receive B(+)
RS-232 Receive and RS-422 Receive A(-)
no connection
Ground
RS-232 Transmit (do not connect for RS-422)
Model 5010-SIE Source ID Encoder Manual
Manual Change Sheet 1.0-3
Page 1 of 3