evertz 5010 SIE Instruction Manual page 59

TECHNICAL DESCRIPTION
panel will display LOAD FLASH - 38400. The default baud
rate for reprogramming is 38400.
To set up the 5010-SIE for programming at 9600 baud hold
down the $ key while you apply power to the 5010-SIE. When
the 5010-SIE completes its boot-up sequence, the front panel
will display LOAD FLASH - 9600
4. The 5010-SIE firmware is contained in an Intel HEX format file
and is called AG52A8.HEX.
(called FL.EXE) was provided along with the upgrade files you
received. This utility uploads the HEX file to the 5010-SIE. Run
FL.EXE, with the appropriate '.hex' file as the first argument.
For example:
This will run the Flash loader program in its default
configuration: COM1, 38400 baud, software flow control.
If you connected the computer using COM2 you will need to
use additional command line parameter to specify the COM port
as follows:
If you set up the 5010-SIE for programming at 9600 baud you
will need to use additional command line parameter to specify
the baud rate as follows:
Entering the FL with no file name will generate a usage
message to show you all the available options for the Flash
Loader program.
5. The Flash Loader will announce that it is erasing the FLASH
PROM,
ERASING...
6. When the Flash PROM is erased, the Flash loader will start to
send the new firmware to the 5010-SIE. The Flash loader will
give a status report as it sends each line of the HEX file to the
5010-SIE.
display will show LOADING - XXXXX. The XXXXX will be the
actual PROM address currently being programmed.
7. If there are programming errors an appropriate message will be
shown on the 5010-SIE front panel. You will need to abort the
Flash loader program by pressing the ALT+x keys on your
computer keyboard. (Hold the ALT key down while pressing the
Model 5010-SIE Source ID Encoder Manual
A Flash Loader software utility
FL AG52A8.HEX
FL AG52A8.HEX /p2
FL AG52A8.HEX /b9600
The 5010-SIE front panel display will show FLASH
During programming the 5010-SIE front panel
Page 4-11