Table of Contents
Advertisement
3.9
PARALLEL REMOTE CONTROL FUNCTIONS
A 9 pin female 'D' connector used for parallel remote control inputs. Loop through outputs have been
provided on two of the inputs for ease of wiring multiple units in parallel. These loop through outputs
are driven in the software so that they follow the sense of the respective inputs. The pinout of the D
connector is as follows:
Pin
1
6
2
7
3
8
4
9
5
VCG KEYER ON/OFF
On and Off. The character inserter is toggled On or Off by a high to low transition on this
input. This input has equal priority with the front panel CHAR GEN ON/OFF key.
ON AIR VCG Disable
windows will be turned off. When this input is released, the VCG windows will revert to the
state they were in before the ON AIR disable input was activated.
GPI
When closed to ground this input sets a GPI bit in the encoded source ID. When the source
ID decoder senses this bit is on it will activate a GPI output.
Date of Issue: September 26, 2001
Description
Ground
not used
VCG Keyer On/Off Input
not used
ON AIR VCG Disable Input
not used
GPI Input
VCG Keyer On/Off Output
GPI Output
Provides an alternate method of turning the character inserter generator
When closed to ground and the On Air mode is set to On, all the VCG
Model 5010-SIE Source ID Encoder Manual
Manual Change Sheet 1.0-3
Page 3 of 3
Advertisement
Chapters
Table of Contents
