evertz 5010 SIE Instruction Manual page 6

SERIAL: A 9 pin female 'D' connector for connection to the RS-232 connector on the D3 video
recorder, the 7225 time code/status converter used with the analog tape machines or the
serial port on a Profile Disk recorder. A loop through output has been provided for ease of
wiring to multiple units.
Pin Description
1 Ground
2 not used
3 RS-232 Receive Loop Through Output
4 Receive Common
5 RS-232 Transmit
6 Transmit Common
7 not used
8 RS-232 Receive
9 Ground
A new section 2.5 is inserted and sections following are renumbered accordingly.
2.5 LINEAR TIME CODE IN/OUT
The LTC reader input provides a means if bringing linear time code from the Profile Disk recorder when
the 5010-SIE is operating in LVS mode. When using an unbalanced input to the reader, the signal
should be applied to pin 3 of the LTC reader input connector. Normally, the unused input, (pin 2)
should be connected to ground (pin 1).
A loop through of this input signal is provided on the LTC OUT XLR connector to facilitate connecting
LTC to multiple 5010-SIE units. Pin 1 of the XLR is ground, and pins 2 and 3 provide a balanced
output.
A new section 2.8 is added at the end of chapter 2.
2.8 CONNECTING THE 5010-SIE TO THE PROFILE RS-232 PORT
When the 5010-SIE is in the LVS mode, it is designed to listen to a serial data stream from the Profile
disk recorder. This serial communication is normally daisy-chained to each of the 5010-SIE units that
are connected on the Profile outputs. This port is used to obtain status and LVS information from the
Profile recorder.
In order to properly address each of the 5010-SIE units connected in the daisy chain, the Profile sends
out an 'address' before each command. The LVS ADDRESS menu item on the Config menu of the
5010-SIE must be set to match the address that the Profile is using for a specific output.
3.1.2 The Character Window Pushbutton Group
CHAR GEN WINDOW
Use the arrow keys to move the window, use the CHAR GEN ON/OFF key to turn the
Date of Issue: September 26, 2001
Initiates VCG window select mode and highlights the Time VCG window.
Model 5010-SIE Source ID Encoder Manual
Manual Change Sheet 1.0-2
Page 2 of 5