Table of Contents
Advertisement
2.
INSTALLATION
The ARC Series modules come with a companion rear panel that occupies one slot in the frame. For
information on inserting the module into the frame refer to section 1.3 of the 7700FR module installation
guide.
2.1.
VIDEO CONNECTIONS
PGM BACK-UP:
This BNC connector is only available on the 7710ARC module, and is used as the
secondary or back-up program video input. This input can be selected as the
primary program video input source via the menu system. (See section 7.3.1)
FILL IN:
This BNC connector is only available on the 7710ARC-F module, and is used as the
video fill input that is keyed into unused portions of the output raster. The video fill
must be frequency locked to the program video input.
PGM IN:
This BNC connector is the primary program video input for 10-bit serial digital video
signals compatible with the SMPTE 259M.
Figure 2-1: 7710ARC and 7710ARC-F Rear IO Modules
7710ARC Series - SD Aspect Ratio Converter
Revision 1.1
7700 MultiFrame Manual
7710ARC-5
Advertisement
Table of Contents
