5.10. PRESETS
5.10.1. Saving and Recalling Configurations
The CD2 modules provide 10 user preset areas to save the complete set of control from the On-Screen
menu. The Store preset and Recall preset menu items are used to save and recall these configurations.
For simplicity the following sections of the manual show how to store and recall from Preset 1 only.
5.10.1.1. Storing Configurations to the User Presets
Presets
Store preset 1
None
User 1 to 10
5.10.1.2. Recalling Configurations from the User Presets
Presets
Recall preset 1
None,
Default
User 1 to 10
Cancel
This control is used to initiate a store of the current module
configuration into one of the user presets. The current configuration
can be saved by selecting one of the 10 user selectable presets and
then depressing the push button.
This control is used to initiate a recall of the current module
configuration from one of the user presets. The user can either select
the factory default configuration of the module or pre-assigned user
presets 1 through 10.
To select a configuration, scroll to the desired configuration and
depress the push button.
Warning: There will be a slight disturbance in the operation of the
module and the On-Screen display while the new preset is being
recalled.
Warning: The current state of the module will be forgotten if it has not
been saved to a preset before a recall is performed.
Revision 1.0
7800 MultiFrame Manual
7737/7837CD2 Dual Composite Decoder
Page - 21