Setting The Motion Detection Controls; Configuring The Scaler - evertz 7700 Manual

7700 MultiFrame Manual
7710UC-HD HD UpConverter

6.5.6. Setting the Motion Detection Controls

2 controls allow you to set the Motion Detection controls
Deinterlacer
Motion Detection
Threshold
4
0 to 15
Deinterlacer
Interfield Weighting
Factor
40
0 to 255
6.6.

CONFIGURING THE SCALER

The 7710UC-HD scaler chip uses a process of filtering to in order to increase the resolution from 720 x
480 (or 720 x 576) to 1920 x 1080 (or 1280 x 720). The Scaler menus are used to configure the cut-off
frequencies of the filters associated with the scaler hardware. The chart below shows the items available
in the Scaler menu. Section 6.6.1 gives detailed information about the menu items.
H Filter Cutoff
V Filter Cutoff
7710UC-HD-20
With this control, you can set the Motion Detection Threshold control. .
With this control, you can set the Interfield Weighting Factor control. .
Sets the cutoff frequency of the horizontal filter in the scaler
Sets the cutoff frequency of the vertical filter in the scaler
Revision 1.3