6.5.6. Setting the Motion Detection Controls
Two controls allow you to set the Motion Detection controls.
Deinterlacer
Motion Detection
Threshold
4
0 to 15
Deinterlacer
Interfield Weighting
Factor
40
0 to 255
6.6.
CONFIGURING THE SCALER
The 7711HDC scaler chip uses a process of filtering in order to reduce the resolution from 1920 x 1080 (or
1280 x 720) to 720 x 480 (or 720 x 576). The Scaler menus are used to configure the cut-off frequencies
of the filters associated with the scaler hardware. The chart below shows the items available in the Scaler
menu. Sections 6.6.1 to 6.6.2 give detailed information about each of the menu items.
H Filter Cutoff
V Filter Cutoff
6.6.1. Setting the Scaler Horizontal filter Sharpness
Scaler
H Filter Cutoff
0.45 fs
0.15 to 0.50 fs
6.6.2. Setting the Scaler Vertical filter Sharpness
Scaler
V Filter Cutoff
0.45 fs
0.15 to 0.50 fs
With this control, you can set the Motion Detection Threshold control.
With this control, you can set the Interfield Weighting Factor control.
Sets the cutoff frequency of the horizontal filter in the scaler.
Sets the cutoff frequency of the vertical filter in the scaler.
With this control, you can set the sharpness of the horizontal filter used
during the down conversion process.
picture.
With this control, you can set the sharpness of the vertical filter used during
the down conversion process. Larger numbers mean a sharper picture.
Revision 1.1
7711HDC HD Broadcast Quality Down Converter
Larger numbers mean a sharper
7700 MultiFrame Manual
7711HDC - 25