Table of Contents
Advertisement
3.7.9.5. Setting the Time of the Event Registers
When one of the GPO assignments is set to GEN EVENT the output activates based on the time
entered into the GEVT register. When one of the GPO assignments is set to RDR EVENT the output
activates based on the time entered into the REVT register.
To access the GEVT and REVT registers press the SHIFT+DISPLAY buttons one or more times until
the display prompt is GEVT or REVT. The ENTER and CLEAR keys are used in conjunction with the
numeric keys to set the value stored in the event registers. Enter a valid time into the desired register
following the same method used to enter the generator time.
When the GEVT or REVT register is being displayed, press the SELECT key to 'arm' the respective
event register for a single event. Press the SELECT key again to 'disarm' the event register. A lower
case 's' will be shown to the left of the hours digits of the display when the register is armed for a single
event. Press the SHIFT+SELECT keys to 'arm' the respective event register for continuous events.
Press the SHIFT+SELECT keys again to 'disarm' the event register. A lower case 'c' will be shown to
the left of the hours digits of the display when the register is armed for continuous events. When the
time code being generated matches the value entered into the GEVT register, the event output will be
activated for the duration set in the GPO DURATION menu. When the time code being read by the
Reader matches the value entered into the REVT register, the event output will be activated for the
duration set in the GPO DURATION menu. When the event register is armed for single event mode,
the output will occur the first time the comparison matches. The event must be re-armed for the event
to occur again. When the event register is armed for continuous event mode, the output will occur each
time the comparison matches.
3.7.10. Configuring The Serial Port
3.7.10.1. Selecting the Serial Port Baud Rate
SERIAL BAUD RATE
Baud rate 2400
Baud rate 9600
Baud rate 19200
Baud rate 38400
3.7.10.2. Testing the Serial Port
SERIAL TEST
Serial test off
Serial test on
OPERATION
Model 8010TM-IRIG SDI Time Code Master with IRIG Reader Manual
The SERIAL BAUD RATE menu item is used to set the baud rate of the
remote control serial port. The 8010TM-IRIG supports four different
baud rates from 2400 to 38400 baud. Select the highest baud rate that
you computer can use for best results.
The SERIAL TEST menu item is used to turn on a serial port test
message.
When the serial test is on, the 8010TM-IRIG outputs a
message similar to:
EVERTZ
DTCG
R020822
Revision 1.4.1
8010TM
SOFTWARE
VERSION
DG86D1.M
Page 3-35
Advertisement
Table of Contents
