Table of Contents
Advertisement
3.7.1. Selecting the Video Type
VIDEO TYPE
Video auto (525)
Video 525
Video 625
3.7.2. Adjusting the Output Level of the LTC Generator
LTC OUT LEVEL
Ltc level xx
3.7.3. Setting The VITC Deleter Line Range
VITC DEL START
Delete Start = xx
OPERATION
Model 8010TM-IRIG SDI Time Code Master with IRIG Reader Manual
The VIDEO TYPE menu item is used to program the 8010TM-IRIG for
the digital video format.
When you select auto the 8010TM-IRIG will auto detect the line rate
and automatically reconfigure itself. The current video standard will be
shown in brackets.
Select 525 for operation with 525 line video conforming to SMPTE
125M.
Select 625 for operation with 625 line video conforming to EBU Tech
3267-E (1992) or the 4:2:2 level of IUT-R 601.
The LTC OUT LEVEL menu item is used to adjust amplitude of the LTC
output. Use the
level setting is 35, which is approximately 1 volt peak to peak.
The VITC DEL START and VITC DEL END menu items are used to
select the lines will be erased by the VITC deleter. This function allows
existing VITC on the incoming program video to be removed prior to
inserting new VITC on the output. VITC deletion is enabled between
the lower and higher line numbers shown (inclusive).
When the VITC DEL START menu item is first selected, the starting
line number for the VITC deleter will be shown. Press the left and right
(
,
) keys to change the starting line. When either the start or end
line number is set to –- the VITC delete function is disabled. Press the
down ( ) key to select the VITC DEL END menu item. Press the left
and right (
,
Revision 1.4.1
and
keys to adjust. The recommended output
) keys to change ending line.
Page 3-28
Advertisement
Table of Contents
