Serial Remote Control Protocol; Overview; Connector Pin Assignment; Table 4-1: Serial Control Pin Definitions - Rs-232 Dce Configuration - evertz 8010TM IRIG Instruction Manual

4.

SERIAL REMOTE CONTROL PROTOCOL

4.1.

OVERVIEW

•
Two wire interface using RS-232C levels or alternate four wire communications channel
using RS-422 levels.
•
Data transmitted asynchronously, bit serial, word serial with data exchange between the
devices being digital.
•
Transmission rate is selectable 38.4 K, 19.2K, 9600 Baud supported
•
Data words utilized by the interface shall be as follows:
1 START bit + 8 DATA bits +1 PARITY bit + 1 STOP bit.
The parity bit shall denote EVEN parity

4.1.1. Connector Pin Assignment

Interface Connector: 9 pin D-subminiature female (DB-9S)
The pin assignment for the serial port when it is configured as RS-232 is:
Pin

Table 4-1: Serial Control Pin Definitions - RS-232 DCE Configuration

SERIAL PROTOCOL
Model 8010TM-IRIG SDI Time Code Master with IRIG Reader Manual
Name
#
1 GND Chassis ground
2 TxD RS-232 Transmit Output
3 RxD RS-232 Receive Input
4
5 Sig Gnd RS-232 Signal Ground
6
7 RTS RS-232 RTS Input
8 CTS RS-232 CTS Output
9
Description
Revision 1.4.1
Page 4-1