Bezel
Figure 97. Optical drive cage removal
Installing an optional optical drive cage
Use this information to install an optional optical drive cage.
To install an optical drive cage, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see
Step 4.
Remove the bezel (see
Step 5.
Slide the optical drive cage forward into the optical drive bay until the screw holes on the drive cage
align with the screw holes on the chassis.
Bezel
Figure 98. Optical drive cage installation
Step 6.
Install the bezel (see
Step 7.
Install the DVD cable (see
Step 8.
Install the cover (see
Step 9.
Reconnect the power cords and any cables that you removed.
Step 10. Slide the server into the rack.
Optical drive cage
"Safety" on page v
"Removing the cover" on page
"Removing the bezel" on page
Optical drive cage
"Installing the bezel" on page
"Installing the DVD cable" on page
"Installing the cover" on page
and
"Installation guidelines" on page
424).
480).
481).
485).
425).
.
Chapter 5
Removing and replacing components
483