Lenovo System x3550 M3 Problem Determination And Service Manual page 174

• 806f050c-2011xxxx : Memory Logging Limit Reached for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName]. (DIMM 17)
This message is for the use case when an implementation has detected that the Memory Logging Limit
has been Reached.
May also be shown as 806f050c2011xxxx or 0x806f050c2011xxxx
Severity
Warning
Serviceable
Yes
Automatically notify support
Yes
Alert Category
Warning - Memory
SNMP Trap ID
43
CIM Information
Prefix: PLAT ID: 0144
User Response
1. Check the IBM support website for an applicable retain tip or firmware update that applies to this
memory error. 2. Swap the affected DIMMs (as indicated by the error LEDs on the system board or
the event logs) to a different memory channel or microprocessor. 3. If the error still occurs on the
same DIMM, replace the affected DIMM. 4. (Trained technician only) If the problem occurs on the
same DIMM connector, check the DIMM connector. If the connector contains any foreign material or
is damaged, replace the system board. 5. (Trained technician only) Remove the affected
microprocessor and check the microprocessor socket pins for any damaged pins. If a damage is
found, replace the system board. 6. (Trained technician only) Replace the affected microprocessor.
• 806f050c-2012xxxx : Memory Logging Limit Reached for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName]. (DIMM 18)
This message is for the use case when an implementation has detected that the Memory Logging Limit
has been Reached.
May also be shown as 806f050c2012xxxx or 0x806f050c2012xxxx
Severity
Warning
Serviceable
Yes
Automatically notify support
Yes
Alert Category
Warning - Memory
SNMP Trap ID
43
CIM Information
Prefix: PLAT ID: 0144
User Response
System x3550 M3Problem Determination and Service Guide
162