Error Messages; System Event Log - Lenovo System x3550 M3 Problem Determination And Service Manual

To clear the IMM system-event log, select System Event Logs ➙ System Event Log ➙ Clear
Step 3.
System Event Log, then, press

Error messages

This section provides the list of error codes and messages for UEFI/POST, IMM, and DSA that are generated
when a problem is detected.
See "POST error codes" on page
and "Diagnostic messages" on page 319

System event log

There are three types of the system event log.
Information
Information messages do not require action; they record significant system-level events, such as when
the server is started.
Warning
Warning messages do not require immediate action; they indicate possible problems, such as when the
recommended maximum ambient temperature is exceeded.
Error
Error messages might require action; they indicate system errors, such as when a fan is not detected.
Each message contains date and time information, and it indicates the source of the message (POST or the
IMM).
Integrated management module (IMM) error messages
The following table describes the IMM error messages and suggested actions to correct the detected
problems.
For more information about IMM, see the Integrated Management Module User's Guide at
support/entry/portal/docdisplay?lndocid=MIGR-5079770&brandind=5000008
Note: Deassertive events not listed in this table are informational only.
List of IMM events
This section lists all messages that can be sent from the IMM.
• 40000001-00000000 : Management Controller [arg1] Network Initialization Complete.
This message is for the use case where a Management Controller network has completed initialization.
May also be shown as 4000000100000000 or 0x4000000100000000
Severity
Info
Serviceable
No
Automatically notify support
No
Alert Category
System - IMM Network event
System x3550 M3Problem Determination and Service Guide
28
twice.
Enter
305, "Integrated management module (IMM) error messages" on page
for more information.
www.ibm.com/
.
28,