Table of Contents
Advertisement
Info
Serviceable
No
Automatically notify support
No
Alert Category
Critical - Hard Disk drive
SNMP Trap ID
5
CIM Information
Prefix: PLAT ID: 0162
User Response
No action; information only.
• 806f000f-220101xx : The System [ComputerSystemElementName] has detected no memory in the
system. (ABR Status)
This message is for the use case when an implementation has detected that memory was detected in the
system.
May also be shown as 806f000f220101xx or 0x806f000f220101xx
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Memory
SNMP Trap ID
41
CIM Information
Prefix: PLAT ID: 0794
User Response
1. Make sure the server meets the minimum configuration to start (see Power-supply LEDs). 2.
Recover the server firmware from the backup page: a. Restart the server. b. At the prompt, press F3
to recover the firmware. 3. Update the server firmware on the primary page. Important: Some cluster
solutions require specific code levels or coordinated code updates. If the device is part of a cluster
solution, verify that the latest level of code is supported for the cluster solution before you update the
code. 4. Remove components one at a time, restarting the server each time, to see if the problem
goes away. 5. If the problem remains, (Trained technician only) replace the system board. Firmware
Error :
• 806f000f-220102xx : Subsystem [MemoryElementName] has insufficient memory for operation.
(ABR Status)
This message is for the use case when an implementation has detected that the usable Memory is
insufficient for operation.
May also be shown as 806f000f220102xx or 0x806f000f220102xx
System x3550 M3Problem Determination and Service Guide
90
Advertisement
Table of Contents
