Table of Contents
Advertisement
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Other
SNMP Trap ID
50
CIM Information
Prefix: PLAT ID: 0766
User Response
This is a UEFI detected event. The UEFI diagnostic code for this event can be found in the logged
IMM message text. Please refer to the UEFI diagnostic code in the "UEFI diagnostic code" section of
the Info Center for the appropriate user response. Firmware Error :
• 806f000f-22010bxx : Firmware BIOS (ROM) corruption was detected on system
[ComputerSystemElementName] during POST. (ABR Status)
Firmware BIOS (ROM) corruption was detected on the system during POST.
May also be shown as 806f000f22010bxx or 0x806f000f22010bxx
Severity
Info
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Other
SNMP Trap ID
40
CIM Information
Prefix: PLAT ID: 0850
User Response
1. Make sure the server meets the minimum configuration to start (see Power-supply LEDs). 2.
Recover the server firmware from the backup page: a. Restart the server. b. At the prompt, press F3
to recover the firmware. 3. Update the server firmware to the latest level (see Updating the firmware).
Important: Some cluster solutions require specific code levels or coordinated code updates. If the
device is part of a cluster solution, verify that the latest level of code is supported for the cluster
solution before you update the code. 4. Remove components one at a time, restarting the server each
time, to see if the problem goes away. 5. If the problem remains, (trained service technician) replace
the system board. Firmware Error :
• 806f000f-22010cxx : CPU voltage mismatch detected on [ProcessorElementName]. (ABR Status)
This message is for the use case when an implementation has detected a CPU voltage mismatch with the
socket voltage.
May also be shown as 806f000f22010cxx or 0x806f000f22010cxx
.
Chapter 3
Diagnostics
93
Advertisement
Table of Contents
