Table of Contents
Advertisement
Figure 81. Filler panel removal
Step 7.
Install the two standoffs on the system board.
Step 8.
Insert the bottom tabs of the metal clip into the port openings from outside the chassis.
Figure 82. Metal clip installation
Step 9.
While you slightly press the top of the metal clip, rotate the metal clip toward the front of the server
until the metal clip clicks into place. Make sure the metal clip is securely engaged on the chassis.
Attention: Pressing the top of the metal clip with excessive force may cause damage to the metal
clip.
Step 10. Touch the static-protective package that contains the new adapter to any unpainted metal surface
on the server. Then, remove the adapter from the package.
Step 11. Align the adapter with the adapter connector on the system board; then, tilt the adapter so that the
port connectors on the adapter line up with the port openings on the chassis.
.
Chapter 5
Removing and replacing components
473
Advertisement
Table of Contents
