Table of Contents
Advertisement
a.
Lift and hold the blue retention tab.
b.
Carefully pull the expansion drive cage at the same time to slide it out of the opening in the
chassis.
Install the optical drive cage
Use this information to install the optical drive cage.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
If there is a filler installed in the bay, remove it. Keep the filler in a safe place for future use.
Step 2.
Install the optical drive cage.
Figure 51. Optical drive cage installation
.
Chapter 4
Server hardware setup
97
Advertisement
Table of Contents
