Table of Contents
Advertisement
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3.
Remove the cover (see
Step 4.
Align the sides of the hard disk drive backplate with the slots on the backplane bracket.
Figure 110. Backplate assembly installation
Step 5.
Insert the hard disk drive backplate into the slots on the backplate bracket and push the hard disk
drive backplate assembly down until the backplate is seated firmly.
Step 6.
Connect the power and signal cables to the system board. Route the power cable from the drive
backplate through the hole on the right of the blue adapter retention bracket and connect it to the
Simple-swap SATA power connector (see
route the signal cable from the drive backplate over the blue adapter retention bracket and connect
it to the Simple-swap SATA signal connector, as shown in the following illustration.
"Safety" on page v
"Removing the cover" on page
"System-board internal connectors" on page
and
"Installation guidelines" on page
424).
.
Chapter 5
Removing and replacing components
17); then,
493
Advertisement
Table of Contents
