Table of Contents
Advertisement
Table 9. DSA Preboot messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
Chapter 4 "Parts listing, Lenovo System x3550 M3 Type 4254 and 7944" on page 403
• See
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)", that step must be performed only by a
Trained service technician.
• Go to the IBM support website at
tips, and new device drivers or to submit a request for information.
Message
Compo-
number
nent
201-804-
Memory
xxx
201-805-
Memory
xxx
201-806-
Memory
xxx
http://www.ibm.com/supportportal/
Description
Test
State
Memory
Abor-
Test
Test
ted
canceled:
the memory
controller
buffer
request
failed.
Memory
Abor-
Test
Test
ted
canceled:
the memory
controller
display/alter
write
operation
was not
completed.
Memory
Abor-
Test
Test
ted
canceled:
the memory
controller
fast scrub
operation
was not
completed.
to determine which
to check for technical information, hints,
Action
1. Turn off and restart the system.
2. Run the test again.
3. Make sure that the server firmware is at the
latest level. The installed firmware level is
shown in the DSA event log in the Firmware/
VPD section for this component. For more
information, see
"Updating the firmware" on
page
513.
4. Run the test again.
5. If the failure remains, go to the IBM website
for more troubleshooting information at
http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-CALL
1. Turn off and restart the system.
2. Run the test again.
3. Make sure that the server firmware is at the
latest level. The installed firmware level is
shown in the DSA event log in the Firmware/
VPD section for this component. For more
information, see
"Updating the firmware" on
page
513.
4. Run the test again.
5. If the failure remains, go to the IBM website
for more troubleshooting information at
http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-CALL
1. Turn off and restart the system.
2. Run the test again.
3. Make sure that the server firmware is at the
latest level. The installed firmware level is
shown in the DSA event log in the Firmware/
VPD section for this component. For more
information, see
"Updating the firmware" on
page
513.
4. Run the test again.
5. If the failure remains, go to the IBM website
for more troubleshooting information at
http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-CALL
Chapter 3
.
.
.
.
Diagnostics
345
Advertisement
Table of Contents
