Table of Contents
Advertisement
Operator information
panel
Figure 112. Operator information panel assembly removal
Step 6.
From the front of the server, carefully pull the assembly out of the server while you move it slightly
from side to side.
If you are instructed to return the operator information panel assembly, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing the operator information panel assembly
Use this information to install the operator information panel assembly.
To install the operator information panel, complete the following steps.
Step 1.
Read the safety information that begins on
417.
Step 2.
From the front of the server, slide the operator information panel into the server until it clicks into
place.
Step 3.
Inside the server, connect the cable to the rear of the operator information panel assembly.
Release tab
"Safety" on page v
and
.
Chapter 5
Removing and replacing components
"Installation guidelines" on page
495
Advertisement
Table of Contents
